Titanium Stakes Manual


Your Titanium Stakes are built to withstand the rigors of the outdoors, but a little care goes a long way in maintaining their efficiency. In case of dirt, clean them with a mild detergent and warm water. Avoid using harsh chemicals as they may damage the stakes. Dry them thoroughly before storage to prevent corrosion, despite their high corrosion resistance.



Your Titanium Stakes come ready for use straight out of the box. No assembly or preparation is needed.



To use your Titanium Stakes:

  • Choose a spot: Select a firm, level spot to pitch your tent or secure your tarp.
  • Position the stake: Place the stake at a 45-degree angle, with the pointed end towards the ground and the cord loop at the top.
  • Hammer the stake: Using a rock or hammer, drive the stake into the ground until the cord loop is barely visible. Ensure that the stake is firmly secured for optimal holding power. Remember to hammer the stake at the same angle it was positioned.
  • Attach guylines or ropes: Fasten your tent's guylines or tarp ropes to the stake using the cord loop. Adjust the tension as needed.

The reflective cord loop on the stakes enhances visibility in low-light conditions, reducing the risk of tripping over them.



To remove your Titanium Stakes:

  • Find the cord loop: Locate the reflective cord loop at the top of the stake.
  • Pull the stake: Firmly grasp the cord loop and pull the stake out of the ground at the same angle it was driven in.



After removal, clean the stakes if necessary and dry them thoroughly. Store your Titanium Stakes in your backpack or a small storage bag to prevent loss.



We appreciate your decision to choose our Titanium Stakes for your outdoor adventures. Our goal is to provide you with reliable and lightweight solutions for your camping needs. Enjoy your journey into the great outdoors, knowing that you're prepared for anything.

Back to blog